Product-specific engineering analysis
Intel RealSense D455 is an active-stereo depth camera designed to provide depth and color information through a USB connection. Intel lists a 0.6-6 m operating range and 1280 × 720 depth resolution at up to 90 fps under specified modes. Those figures do not guarantee accurate depth on every surface or at every distance.
Will D455 see a thin black object at six metres?
Intel's specifications state the operating range, while stereo accuracy also depends on available visual detail, illumination, reflectivity, range and the selected sensor mode. A dark, thin or shiny object can yield unreliable or missing depth even inside the range interval. Build a test with a measured rod, matte box and reflective surface at several distances.
Record depth accuracy against a physical reference, the proportion of valid pixels and whether the object is detected on successive frames. A robot that must stop before a low obstacle needs coverage at the actual camera height and the full stopping-distance margin. A camera alone does not provide safety-rated protection.
Which USB and host settings affect D455 performance?
Intel's technical page identifies USB 3.1 as the system interface. Achievable camera modes and frame rate depend on host bandwidth, compatible firmware, SDK, cable length and the combination of enabled depth and RGB streams. A USB connection shared with other cameras or storage can become a source of delays and dropped frames.
Record the camera firmware, RealSense SDK version, color and depth resolutions, synchronization setup and host CPU use. Repeat the test with navigation or manipulation software running. If a frame arrives late, a gripper can plan a grasp against an object pose that is no longer current even when individual depth pixels are accurate.
How should the camera be calibrated to a robot arm?
A useful depth map must be expressed in the robot's coordinate system. Calibrate intrinsics, measure camera-to-base or camera-to-tool transformation and verify the result with several known reference points. Test the camera after the bracket is tightened or the tool is changed. The final pick error includes camera calibration, motion-control error and the gripper's contact geometry.
For bin picking, count correct object placements across repeated trials rather than declaring success because a point cloud renders correctly. When comparing with a ZED 2i or a time-of-flight camera, use the same objects, lighting, distance, target positions and robot motion. This produces a defensible application comparison.